Instructions / Assembly

USACC-RF-3UNIVERSAL LEAD-FREE DRINKING WATER FAUCET
INSTALLATION INSTRUCTIONS
NOTES
• Install this faucet on the cold water line only.
• Comply with all state and local laws regarding the installation of
water treatment devices.
• Avoid placing the faucet in direct sunlight, excessive heat
or freezing temperatures. Do not use with electrical heating
equipment.
• Use only soap and water to clean.
INSTALLATION
The faucet can be used with most undersink water ltration
systems. Your undersink water ltration system was installed with
either a stop valve adapter tee or with a saddle valve assembly.
Both methods are used to tap into the cold water line.
1. Remove old faucet
A) From the underside of the sink, locate and turn off the cold
water shut-off valve located on the cold water line.
B) Open the old faucet on the sink to relieve pressure on the
system.
C) Find the connection between the faucet stem and the 1/4-
inch water supply tubing.
D) Loosen the hardware and remove the water supply tubing
from the faucet. Place the tubing end in a pan to catch any
water leaking from the disconnected tubing.
E) From the top side of the sink, remove the rest of the old
faucet.
2. Install the faucet
A) Remove small parts bag for faucet from plastic bag.
B) Insert small black rubber washer, metal escutcheon plate
and large black rubber washer on threaded stem of faucet.
C) Insert faucet stem into hole in sink or countertop.
D) From under the sink, slide the black plastic locating washer,
lock-washer and lock nut onto threaded stem of faucet.
E) Tighten nut hand-tight and recheck position of faucet on
sink. Tighten nut with wrench until faucet is secure. Do not
over-tighten lock nut. Hint: Have someone hold faucet in
desired position on top of sink while tightening the nut.
2
Lock-washer
Lock nut
Locating washer Escutcheon plate
Large washer
Small washer
3. Reconnect the cold water line
A) Cut (trim) a short section off the end of the poly tubing that
was in the old faucet.
B) Slide compression nut and ferrule onto the tube. Insert
plastic insert into end of tubing. Insert tube into faucet
stem and hand-tighten compression nut. Tighten
compression nut 1
1
⁄2 — 2 turns with a wrench.
4. Turn the water back on
A) Open the faucet and then slowly open the cold water shut
off valve.
B) Flush faucet for 5 minutes before using.
C) Check for leaks at all the ttings.
3B
Tubing insert
Compression nut
Ferrule
OMNIFILTER
13845 BISHOPS DR., SUITE 200, BROOKFIELD, WI 53005 U.S.A.
|
P. 262.238.400
|
CUSTOMER SERVICE: 800.279.9404
|
[e-mail]
|
pentair.com
All indicated Pentair trademarks and logos are property of Pentair. Third party registered and unregistered trademarks and logos are the property of their respective owners.
© 2022 Pentair. All rights reserved. 4006757 Rev A AU22