User Guide
Rev01 - PoE Adapter Quick Start Guide - ©2020 Omnidots
INSTRUCTIONS PRIOR TO FIRST USE
QUICK START GUIDE
PoE adapter
IP65 connector sleeve
PoE Adapter
Power over Ethernet
The PoE adapter provides the Omnidots SWARM with both Ethernet and
power, using one cable. When using the PoE adapter you can install your
SWARM in places with no 3G / 4G / LTE or WiFi connecon, or in places
where you cannot use an Omnidots Baery, Solar panel set or mains
power. The PoE adapter is the ideal product for monitoring at for example
very remote areas or in a basement or tunnel.
Requirements
To use Power over Ethernet for your SWARM, you will need the following:
An Ethernet network with an acve DHCP server which assigns local IP
addresses. E.g. a PoE Ethernet switch or an Ethernet switch combined with
a PoE power injector.
An Ethernet cable, recommended Cat5e UTP (or higher), with a maximum
length of 100 meters (328 ).
Important noces
Omnidots’ hardware product is warranted against defects in materials and
workman- ship for a period of two (2) years from the date of original
purchase, and only when used in accordance with Omnidots’ user manuals
and instrucons. IP65 connector and enclosure IP rated as dustproof and
protected against water projected from a nozzle.
Make sure to use the supplied IP65 connector sleeve on your Ethernet
cable to make sure your PoE soluon is IP65 protected. Not using the IP65
connector sleeve will void the warranty. The PoE adapter should never be
opened. Only an Omnidots Cerfied facility can do so.