Installation
FOR 45mm & 55mm SURFACE MOUNTED ROSES
INSTALLATION INSTRUCTIONS FOR
LATCHSETSOMNIA TRADITIONS
1. Using template, mark all points for drilling. Use correct
backset for latch. For 1¾" and 2" diameter roses or
narrow plates, drill ¾" diameter hole. Do Not drill a
2 " bore.
2. Using 1" bit, drill from door edge through the door to
accommodate latch length.
3. With face cover in place, position latch and mark perimeter
of latch faceplate on door edge. Mortise to accommodate
latch face and face cover, approximately " deep.
4. When installing the latch, hold latch with writing facing
upwards.
5. Position latch in door to suit bevel. Rotate latch bolt if
necessary, using slight pressure. Apply faceplate with flat
side of faceplate facing flat side of latch bolt. Screw the
faceplate and the latch to door.
INSTALLING ROSES:
6. Insert spindle through latch hub with the slot of the spindle
facing the hinges (for levers) or downwards (for knobs).
Place sub-roses (3B) onto spindle (6) on both sides of the
door. Slide levers/knobs onto the spindle (6). Mark each
sub-rose for three screw holes with pencil, then drill pilot
holes. Remove levers/knobs and fasten sub-rose to the
door with wood screws (4). Apply cover roses (3A) on
both sides of door.
7. Slide nylon washers (10) onto shank of levers/knobs. Slide
levers/knobs onto roses until securely seated inside of
roses. Insert the set screws (2) into the levers/knobs and
fasten to the spindle.
Your Omnia Dealer/Distributor can help you with any further
questions or information on other Omnia Products.
This set WILL NOT cover a 2 ”pre-bored door
1
/
8
This set WILL NOT cover a 2 ”pre-bored door
1
/
8
8
1
/
5/
32
CEDAR GROVE, NJ 07009
MNIAO
INDUSTRIES , INC.
R
12/29/10
OMTRAD-TLC
TUBULAR LATCH TEMPLATE
FOLD ALONG DOOR EDGE
DRILL 1" DIA. HOLE
IN DOOR EDGE
1 "
DOOR
3
4
" BORE
3
4
2 " BACKSET
3
8
1 "
DOOR
3
8
38" FROM FLOOR
3
4
2 " BACKSET
11
16
"
7
8
"
5
32
"
FACEPLATE
1” x 2 ”
1
/
4
NOTE: Template may not be true-to-size. Please use for reference
purposes only. DO NOT drill until measurements are verified.