Installation Sheet

A
D
Ea
F
C
G
Eb
N
N
B
A
B
C
K
L
M
D
O
Q
J
I
H
P
INSTALLATION OF PRIVACY LATCH
(PRIVACY LATCH FOR LEVERS ONLY)
Figure #2
Hold latch with writing on label facing upwards. The side of the
latch that is inside of the room must be towards you. Push in
the privacy locking block. Slide the oval plastic stopper over the
outside privacy block. Fasten with the small machine screw.
*NOTE Thread privacy pin into latch after trim is applied.
Privacy locking
block
Label
Privacy Pin
(Inside of Room)
Plastic
Oval
Stopper
Screw
Figure #3
FACEPLATE AND STRIKES
DRAWINGS NOT TO SCALE
OMNIA
OMNIA
FACEPLATE NO. 13
“T”STRIKE -
STANDARD
NO. 14
“FULL LIP” STRIKE -
OPTIONAL
NO. 19
“ASA” STRIKE -
OPTIONAL
Figure #4
Rose Set
CEDAR GROVE, NJ 07009
Latchset Component List
A) Door Knob/Lever (2)
B) Set Screw (2)
C) Nylon Threaded Washer (2)
D) Finished Rose (2)
Ea) Metal Spring Assist Sub-Rose
Eb) Metal Spring Assist Sub-Rose
F) Spindle (Teardrop groove positioned towards
set screw)
G) Tubular Latch
H) Privacy Locking Block Machine Screw
I) Privacy Locking Block Locking Stopper
J) Privacy Locking Block
K) Tubular Latch Faceplate
L) Tubular Latch Strike Plate
M) Tubular Latch Dust Box
N) Thru-Bolt Machine Screws With Locking
Washer (2)
O) Washer Installation Tool
P) Privacy Locking Pin (For Privacy Only)
Q) Emergency Release Key
OM-TL
2/10/2020
Washer will fit on
either side, but
MUST be installed
on OUTER side.
ATTACHING LATCH TO FACEPLATE
Figure #1
NOTE: Must attach faceplate to latch (as shown
here) prior to installing latch in door.
(Please see Figure #2 regarding privacy latch.)