Installation Sheet

Installing Latch - Skip to #4 Instruction if door is pre-bored.
1. Using template, mark all points for drilling. Use correct
backset for latch. Drill 28" bore first. For 2" diameter
roses or narrow plates drill ¾" diameter hole instead of
28" bore.
2. Using 1" bit, drill from door edge across the bore to
accommodate latch length.
3. With face cover in place, position latch and mark perimeter
of latch faceplate on door edge. Mortise to accommodate
latch face and face cover, ®" deep.
4. PASSAGE: When installing a passage latch, hold latch
with writing facing upwards.
PRIVACY: When installing privacy latch, hold latch with
writing facing upwards. From inside of the room, push
the "Privacy Locking Block" toward the outside of the
room. Slide the oval plastic stopper over the outside
privacy block. Fasten with the small machine screw
(see Figure #2 on reverse side).
5. Apply faceplate to latch with flat side of faceplate facing flat
side of bolt (see Figure #1 on reverse side). Position latch
and faceplate in door to suit the door swing. Rotate if
necessary, using slight pressure. Screw latch and
faceplate to door.
BEFORE INSTALLING ROSE:
6. Insert spindle through latch hub. FOR PRIVACY: Insert
split spindle until spindle stop hits latch hub. The "tear
drop" cut outs on the spindle should be facing the set
screw hole on lever or knob.
NOTE: Template may not be true-to-size. Please use for reference
purposes only. DO NOT drill until measurements are verified.
INSTALLATION INSTRUCTIONS FOR LATCHSETS
CEDAR GROVE, NJ 07009
Your OMNIA Dealer/Distributor can help you with any further
questions or information on other OMNIA Products.
CAUTION: DOOR AND FRAME MANUFACTURERS
When door gasketing or silencers are used, proper allowances must be made for strike location to
maintain a common centerline with lock and door so that the bolt will freely enter strike.
OM-TL
2/10/2020
Installing Passage and Privacy Rose Set
1. Place the metal sub-roses together through the door (slide
both sides of the sub-roses onto the spindle). Make sure
both sub-roses have the word “UP” facing upwards.
Fasten the sub-roses together using the (2) screws
provided. Tighten the screws to fasten the sub-roses
together.
2. Install the rose covers onto the metal sub-rose by aligning
the two “tabs” of the rose with the two “notches” on the
outside of the sub-rose. Tighten the two threaded washers
with the tool (O) provided.
3. For a privacy set, the small hole in the rose cover should
face the door edge. From the inside of the door, insert the
privacy pin into the rose hole and thread into the privacy
locking block of the latch.
4. Partially insert the provided set screws into the levers.
Slide both levers onto the spindle until securely seated
into the threaded nylon washers. (For privacy, ensure the
spindle is centered in the latch so that each lever works
independently.) Tighten the set screws onto the spindle.
5. Check for smooth operation.