User's Manual

Omnia 4.5 Use and Installation Guide – Version 1.00a
1
1
Chapter 1 – Pre-installation
We believe that the Omnia-4.5fm is the easiest processor to install in its class. But please take a few minutes to read
this chapter before proceeding with the installation.
Pre Installation Tasks
This section offers common procedures for installing your new Omnia-4.5fm processor. Note that there are additional
installation and operation tips presented in Chapter 4 that may pertain to your specific installation.
Omnia-4.5fm Components
By now you’ve unpacked the shipping carton to gain access to this manual. Now is the time to inspect the Omnia-
4.5fm unit and its shipping carton for any signs of shipping damage, which must be reported to your carrier for any
claims. The Omnia-4.5fm shipping box includes the following components:
➤ Omnia-4.5fm processor (containing the DSP hardware)
➤ Omnia-4.5fm PCMCIA Type Memory card (holding the DSP software)
➤ Omnia-4.5fm Operating Manual (this document)
➤ Warranty Registration Card (Please complete the form and return/FAX it to Telos/Omnia)
➤ Two IEC Power Cords, one for use in the US, and one for use in Europe
PC Card & Modem Installation
Before installing your Omnia-4.5fm, or even plugging in the power cord, make sure the Omnia-4.5fm PC Memory
Card and optional Modem Card (if ordered) are installed into the correct card slots on the back panel and are fully
seated. Installation or removal of cards must be done with the power off unless directed otherwise.
The PC Memory Card is inserted into the top card slot with the Omnia label facing up. The optional Modem Card is
inserted into the bottom card slot below the Omnia PC Card. Both the PC Card and the Modem Card are keyed to
prevent improper insertion. Gently
press the cards into the slots until the black release button, to the right of the card,
pops out about 1/2" [12.70 mm]. This indicates the card is properly seated in the PCMCIA slot.