MULTIFUNCTIONAL CABINET LOCK
01. Product Description A smart cabinet lock, a variety of unlocking methods (optional single and any combination of unlocking methods) 1. Touch the keyboard to enter the password to unlock 2. RFID card swipe to unlock. 3. Fingerprint unlock. 02.
、Lock Pin Front side Perspective 03. Specifications Product name Smart cabinet lock BLE BLE4.0 （2402-2480MHz） RFID card 13.56Mhz,YPE-A,TYPE-B Fingerprint Semiconductor fingerprint module, 1-100 users Amount of users 100 groups, each group can be combined with password and RFID, or combination of password and fingerprint Operating temperature -10℃ ~ 60℃ storage temperature -40℃ ~ 70℃ Working humidity 93%RH Working current <80mA(3.
recharging current <500mA(5VDC) voltage 3.7VDC Battery standby 2year Shell material Dimensions ABS Control panel 69.9x53.4x13mm lock body 63x58x22.6mm 04. Instructions 4.1、Function Description： To wake up, press any touch button, and the white light will indicate that you have changed to wake up. The keyboard is unlocked, enter the 6-digit password, and press OK to confirm. If the password is correct, the green light is on and a long beep sounds. The lock is unlocked.
Delete all passwords to restore factory mode; add at least one user password to switch to user mode. The password is entered incorrectly 5 times in succession, the keyboard is locked, the red light is on, and it returns to normal after 2 minutes. virtual password function, enter any password before the correct password to prevent peeping, as long as the last 6 digits of the password are correct, the lock can be unlocked Charging: Use a type-c usb cable to charge the machine.
4.3、Buzzer status： Short touch of the touch button The lock is unlocked correctly and the sound is long 4.
If you are adding an RFID card, swipe the card once, if the addition is successful, the green light flashes, and if you already have the current card, the red light flashes If you are adding a fingerprint, you need to press your finger for about 3 to 5 seconds until the green light flashes 4 times successfully Note： If adding RFID or fingerprint to the current user, add it before the blue light goes out If you add the next user, you need to wait for the blue light to go out.
2. The user associates the password and RFID or fingerprint. Afteradding a password, add the RFID or fingerprint before the blue light goes out. (The association method is password + RFID, password + fingerprint.) 3.All the input is a single password verification, and the associated password is used to record which user 4.
Control panel installation The panel needs to be pasted at the corresponding position before installation Positioning stickers drilled 2 Φ 3mm and A hole of Φ 8mm Screw on (2 pcs Φ 3mm) Lock body installation 4 M3 * 20 self-tapping screws
Precautions for installation The lock body and lock latch seat should be installed in parallel with the drawer, sliding door, etc.
4.5、FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
