User's Manual

Setup Procedure
12
RF signal to penetrate the sidewall is small, carefully
aim OmiDetect halfway between the tire rim and the tire
tread.
3. Power On the OmiDetect tester, by pressing and holding
down the power On/Off button for 2 or 3 seconds. You
will hear a beep and the LED array will illuminate and
display the last test mode used.
4. Select TPM sensor mode by pressing the power On/Off
button until the LED under the Tire symbol illuminates.
With each press of the power On/Off button, you will
hear a beep and the LED display will alternate between
the Listen and the TPM sensor mode LEDs.
Important: As a battery life saving feature, if you do not
select a sensor type within 30 seconds of powering On
OmiDetect, it will assume no testing is required and
automatically power itself Off.
If the sensor you are testing is not currently supported
by OmiDetect, refer to Sec. 6 for information on how you
can activate the sensor manually.
5. Press the button to test the sensor. The TPM LED
illuminated will begin to flash to indicate OmiDetect is
activating the sensor and listening for the appropriate
RF signal from it.