User's Manual

Safety Information
8
6. Never clean a TPM sensor/transmitter with compressed air or
steam. Damage to the sensor/transmitter may result.
7. The cap on the valve stem or a TPM sensor/transmitter
frequently contains a O-ring to prevent contamination and
moisture from entering. Be sure to retain this cap for reuse.
8. Strong radio waves may interfere with the proper operation of
some TPM systems.
9. Snow, ice or mud in the wheel wells and tire chains mounted
on the tires may cause a TPM system to malfunction.
10. Check that the vehicle’s ignition is Off and that its parking
brake is properly set.
11. Do all testing in a well-ventilated area.
12. Do not smoke or allow sparks or open flame near fuel system
parts.
13. Do not smoke or allow open flame near a battery.
14. Do not wear watches, rings or loose-fitting clothing when
working near operating equipment.
15. Wear safety goggles at all times while operating OmiDetect.
Rotating equipment components or electrical equipment can
cause flying particles.
●
CAUTION – General Operating Precautions
1. Keep OmiDetect away from metal objects, such as clamps,
wheel alignment or other tire/wheel equipment, since they will
impede OmiDetect’s ability to receive a good RF signal from a
TPM sensor.
2. Keep OmiDetect away from any known RF transmitters, such
as mobile phones and other RKE (Remote Keyless Entry)
transmitters. Signals received from these devices could result
in the incorrect RF signal being detected.
●
Caution – Misdiagnosis may lead to incorrect or improper
adjustment and/or repair.
1. Do not rely on erratic, questionable or obviously erroneous test
information or results. If test information or results are erratic,
questionable or obviously erroneous, verify that the test
procedure was performed correctly. If test information or
results are still suspicious, do not use them for diagnosis.
Improper adjustment or repair may cause equipment damage
or unsafe operation.