Owner's Manual

Setup Procedure
12
Important: Do not aim directly at the valve stem. Since it is
metal, it will impede receiving a good RF signal from the
sensor. With low-profile tires, since the area for the RF signal
to penetrate the sidewall is small, carefully aim OmiDetect
halfway between the tire rim and the tire tread.
3. Power On the OmiDetect tester, by pressing and holding
down the Power On/Off button for 2 or 3 seconds. You will
hear a beep and the LED array will illuminate and display the
last test mode used.
4. Select the appropriate type of sensor to be tested by pressing
the power On/Off button repeatedly until the required