Owner's manual

4.3.6.6 Passcode ID

This submenu is for the 1/8 DIN Panel Meter-Controller version of the zSeries.

and is used to prevent unauthorized tampering with the setup parameters. The

meter provides protection by requiring the user to enter the ID Code before

allowing access to subsequent menus of the meter’s front panel. If the ID Code

entered does not match the ID Code stored, the meter responds with an error

message and access to subsequent menus will be denied.

This would not be used for the DIN Rail version of the zSeries, as there are no

front panel push buttons.

Figure 4.17 ID Code

Setpoint ID

Disabled

Full ID

Disabled

0000

Main Menu

SETUP

Passcode ID

SETUP

http://192.168.1.200Address

Cancel

Update