Owner's manual

32
4.3.5 Controller Setup (continued)
Below are the definitions of terms used in the Controller Setup page.
A) Setup:
Clicking on the options shown, allows user to modify the different parameters
shown under this menu (see Section 4.3.6. Setup Page for more details)
B) Monitor:
If you have the DIN Rail version of the zSeries, leave settings as shown below
(default) as there is no front panel display;
Scrolling: Checked, default.
End Device ID: Not applicable.
C) Transmission Power:
PID (Network ID): The Personal Network ID (0 to 65535). In parenthesis is the
firmware version of the radio module. The firmware version is also shown on a
label attached to the wiDR (see Figure 3.1).
The wiDR always has an address of 0.
Channel: Choose the operation channel defined in IEEE 802.15.4 for the
sensor network.
Transmission Power: This determines the signal power transmitted by the
wiDR. The options are 10 dBm and 20 dBm.
Please refer to local regulations for the allowed maximum transmission
power.
For additional details, please refer to Appendix F.
D) Miscellaneous:
iSeries Version: The firmware version of the wiDR controller, also shown on
model/serial label (See Figure 3.1).
Changes made on the Controller Setup page will take place after clicking
the Reset Controller button or simply power recycling the wiDR