Owner's manual

2.1.5.3 Dip Switches
To change the DIP switches, follow the instructions below:
1. Locate the 4 and 8 position DIP switches.
The wiDR is shipped with all DIP switches in "OFF" position
To set the Wireless and Ethernet settings to Factory Default, Refer to
Section 7.
Figure 2.10 Location of DIP Switches
4 Position DIP Switch 8 Position DIP Switch
1 Not Applicable 1 To change the Wireless
settings to Factory Default
2 To change the Ethernet settings 2 - 8 Not Applicable
to Factory Default
3 To enable/disable DHCP
4 Not Applicable
18
ON
OFF
ON
N/C 1
DEFAULT 2
DHCP 3
N/C 4
13
4 Position DIP Switch for
Ethernet settings
8 Position DIP Switch for
Wireless settings