User's Manual

Appendix H Telnet Setup (continued)

s Is the configuration command, used to set a new setting (see the

example in Figure I-3)

RESET Following with a return character, it will recycle the Power on the

iServer.

FACTORY Following with a return character, it will set the iServer to it’s factory

default settings.

c The current settings will be stored permanently .

q quit

Administrator Password?00000000

iSeries>?

Available Commands:

1. RESET (To reboot the device)

2. FACTORY (To restore factory defaults)

3. ? (Help/This screen)

4. c (confirm settings and write to the flash)

5. p (Print the settings)

6. q (Quite this console)

7. s-<ARG><VALUE> (To change device settings)

+-------------------------------------------------------------+

| Arg | Description | Value |

+-------------------------------------------------------------+

| BD | BaudRate | 1-300, 2-600, 3-1200, |

| | | 4-2400, 5-4800, 6-9600, |

| | | 7-19200, 8-38400 |

| | | 9-57600, 10-115200, |

| | | 11-230400, 12-460800 |

| DT | Data Bits | 1-5 bits, 2-6 bits, |

| | | 3-7 bits, 4-8 bits |

| PT | Parity | 1-none, 2-even, 3-odd |

| ST | Stop Bit | 1-1 bit, 2-2 bits |

| FC | FlowControl | 1-none, 2-hw, 3-sw |

| DP | DHCP | 0-Disable, 1-Enable |

| IP | IP address | |

| SM | Subnet mask | |