SSHB, SRMU, SEPHB SERIES Silicone Rubber Heating Blankets
TABLE OF CONTENTS Introduction................................................................... 2 Safety Alert Symbol....................................................... 2 Important Safety Instructions……………...................... 3 Prior to Installation........................................................ 4 Mounting Your Heating Blanket..................................... 5 Connecting Your Heating Blanket to a Power Source... 6 Troubleshooting Guide..................................................
PRIOR TO INSTALLATION PRIOR TO INSTALLATION Hardware: Read and understand this entire manual before operating this electric heater. junction box wire ties mounting hardware 1. Check for suspected damage to the heating blanket like rips, punctures, etc. plug if connecting heater to a receptacle rather than hard wiring to a temperature controller or junction box. 2. Verify surface to be heated is free from all sharp edges, weld splatter, rust, oil, etc.
MOUNTING YOUR HEATING BLANKET Installation of heater using factory supplied Pressure Sensitive Adhesive (PSA): 3. Peel off the release film [Figure A] and then press the heater onto the surface of the item being heated using a medium to hard rubber roller [Figure B]. Ensure blanket is making intimate contact with the surface to be heated. - The pressure sensitive adhesive will cure when the blanket is energized and heat is generated.
M-4281/06 PN: 11661-01 Rev 0
