Owner's manual

Chapter 2: Installation and Configuration
28
J1 Connector (PDL/PDXI-DIO)
If you wish to develop you own custom cable, you can purchase the
connector and metal cover from your distributor or the factory. The
part number is PD-CONN.
The manufacturer is:
Fujitsu Takamisawa America, Inc.
Telephone: [phone] Fax: [phone]
The manufacturers’ part number for the connector is FCN-230C096-
C/E and the metal cover FCN-247J096-G/E.
Custom terminal panels are available. Please contact your distributor or
the factory.
J3 Counter/interrupt Connector (PDL/PDXI-
DIO)
PowerDAQ board has a dedicated connector for the DSP counters and
interrupts, which is a 14-pin non-boxed 0.1” header on PD2-DIO boards
and 16-pin boxed 0.1” header on all other models.
In all cases mated IDC cable part number will be FCS-16-SG
The manufacturer is Adam Technologies, Inc.
Telephone: [phone]
Fax: [phone].
J4 ESSI Connector (PDL/PDXI-DIO)
PowerDAQ board has a dedicated connector for the DSP ESSI ports,
which is a 2x12-pin non-boxed 0.1” header on PD2-DIO boards and 26-
pin boxed 0.1” header on all other models.
In all cases mated IDC cable part number will be FCS-26-SG
The manufacturer is Adam Technologies, Inc.
Telephone: [phone]
Fax: [phone].