Owner's manual

Chapter 2: Installation and Configuration
19
Accessories
PowerDAQ DIO boards are supplied with a large range of accessories:
• Cables
• Screw terminal panels
• Complete kits
• Signal Conditioning
• OEM distribution panel
Cables
Note To insure minimum (DIO only) board functionality
the following cables must be used, (depending on
the board model): PD2-DIO-64x – PD-DIO-CBL-100,
PD2-DIO-128x – 2 x PD-DIO-CBL-100.
PD2-DIO Series
The J1/J2 connectors use a 100-way 1-meter high-density IDC cable (PN
PD2-DIO-CBL-100).
The J3 connector uses a 16-way 18” twisted pair cable to connect
IRQ/Counter lines to the screw terminal or user board (PN PD2-DIO-
CBL-16).
The J4 and J5 connectors use a 26-way 18” twisted pair cable to
connect ESSI lines to the screw terminal or user board (PN PD2-DIO-
CBL-26).
Custom cables are available. Please contact your distributor or the
factory.
PDL-DIO Series
The J1 connector uses a 96-way 1-meter round shielded high-density
cable (PN PD2-DIO-CBL-96CE).
The J3 and J4 connectors uses specially designed splitter cable that
brings signals from those two connectors to the 37-way bracket and,
through this bracket, back to 14 (J3) and 26 (J4) connectors on the
PDL-DIO-STP-64 (PN PDL-DIO-CBL-37).