Owner's manual

Chapter 2: Installation and Configuration

Figure 2: PowerDAQ control panel application showing PD2-DIO-

64 board installed

There is a diagnostic program supplied with PowerDAQ SDK called DIO

Test Application (DIOTest.exe). This program is located in PowerDAQ

program folder in Windows Start/Programs menu. You can run this

program and actually verify the functionality of the DIO. The program

performs “running light” test for every I/O, by default I/Os are

configured as an inputs, but if you will wire up the Port0 (DIO0..15) to

Port1(DIO16..31) and Port2(DIO32..47) to Port3(DIO48..63) using the

100 Ohm-1K resistors (PDL-DIO-STP provide jumpers to make the

connections above, but be careful and do not enable both ports,

connected together as an outputs because there are no current limiting

resistors on the PDL-DIO-STP-64).