Owner's manual

Chapter 2: Installation and Configuration
10
Installation and Configuration
This chapter describes the hardware and software installation and
configuration of the PowerDAQ DIO board.
Unpacking
Your PowerDAQ DIO board is wrapped in an anti-static bag to protect
against electrostatic charges that might damage the board. To avoid
damage, proceed as follows:
1. Ground yourself with a grounded wrist strap or
grounded source.
2. Discharge the static electricity by taking the board in
the antistatic bag and touching the metal part of your
PC.
3. Remove the board from the antistatic bag. We suggest
you save the bag.
4. Inspect the board for any damage. If any damage is
found, return the board to the manufacturer.
See
Appendix D: Common Questions and Support.
Note Although all PowerDAQ DIO boards were designed
with maximum protection against ESD discharge,
they still contain sensitive electronic components.
Please make sure the proper grounding and
electrostatic conditions are used.
Hardware
PCI Installation instructions (PD2-DIO and
PDL-DIO)
You can install you PowerDAQ PD2-DIO or PDL-DIO board in any PCI
slot. We recommend you use the first available slot and complete the
following instructions:
1. Turn off your PC.
2. Remove the cover and make sure you have clear access
to the PCI slots.