Owner's manual

To insert the Mini SD card:
a. Lift up the rubber flap at the bottom of the camera to expose
the jacks and SD card slot.
b. Position the Mini SD card with the printed side up (metal
connector side down) in the slot at the bottom of the camera.
c. Push the card in gently with your fingertip until you feel and
hear a click.
3. POWER ON
a. Remove the lens cap by pulling it forward.
b. Flip up the LCD to expose the keypad.
c
. Press and hold the button at the upper right of the keypad
for 3 seconds. The System Information startup screen will
appear and take 40 seconds to clear. On the OSXL-TIC101 and
OSXL-TIC102, the LED at the upper left of the keypad will glow
green. On the OSXL-TIC103 and OSXL-TIC104, the LED will
toggle between green and blue, indicating that the camera
is ready for a Bluetooth connection.
4. MANUAL FOCUS
Turn the focus ring until the image becomes sharp. Press the
Auto Adjust button to automatically select the level and span
(
brightness and contrast).
5. CONFIGURING THE TRIGGER TO…..
a. Save images
• By default, squeezing the trigger saves the current display
as an image file.
b. Freeze/Activate an image
• Press the MENU/ENTER button to open the Main Menu.
• Press the
or button to navigate to the Trigger Setup
line. Then press the MENU/ENTER button to open the
Trigger Setup Menu.
• Use the
or button to highlight Freeze/Live. Then
press the MENU/ENTER button to save the selection.
• In this configuration, squeezing the trigger freezes the
current image.
c. Turn the torch light on and off
• Press the MENU/ENTER button to open the Main Menu.
• Press the
or button to navigate to the Trigger Setup
line. Then press the MENU/ENTER button to open the
Trigger Setup Menu.
• Use the
or button to highlight Torch On.
• Note: Pressing the MENU/ENTER button changes the
selection from Torch On to Torch off (disabling
the torch).
• With the torch light enabled, squeeze and hold the trigger
then press the Auto Adjust button to turn on the torch and
repeat to turn it off.
d. Turn the laser pointer on and off
• Squeezing and holding the trigger for 3 seconds turns the
laser pointer on and off.
6. TOGGLING BETWEEN SAVE FILE AND FREEZE/LIVE
Pressing the SAVE/FREEZE button toggles the trigger’s action
between Save File and Freeze/Live.
7. OPENING A SAVED IMAGE
a. Press the MENU/ENTER button to open the Main Menu.
b. Press the MENU/ENTER button again to highlight Open.
c. Press the MENU/ENTER button a third time to open a
directory of saved image files.
d. Use the
or buttons to select a file. Then press the
MENU/ENTER button to open it.
WARNINGS
• DO NOT POINT the camera directly at the sun, a laser, an arc
welder, or a source of intense heat far hotter than the unit’s
measuring range. Doing so for more than a few seconds will
permanently damage the camera’s IR sensor
and void the
camera’s limited warranty.
• DO NOT AIM the laser pointer at a person or animal.
Prolonged exposure may damage eyesight.
QUICK-START GUIDE