Instructions for the Use and Care and Installation of ORC93XA ORC94XBA Wall Canopy Rangehoods
CONTENTS 1 Warning 2 Features 3 Installation 4 Notice of installation 5 Safety Warning 6 Use Instructions 7 Maintenance 8 Troubleshooting 9 Specification It is important that you retain these instructions, proof of purchase as well as other important documents about this product for future reference. Due to continual product development, Omega reserves the right to alter specifications or appearances without notice. Dispose of packaging responsibly – recycle where facilities are available.
(1) Warning • Young children should be supervised to ensure that they do not play • • • • • • • • • • • with the appliance. The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervised or instruction concerning use of the appliance by a responsible person for their safely.
(2) FEATURES 1. The cooker hood uses high quality materials, and is made with a streamlined design. 2. Equipped with a high power electric motor and centrifugal fan, it produces strong suction with low noise, and features a non-stick grease filter which is easy to clean. 3. The isolated low voltage (12 volt) circuit board control, means the halogen lights are brighter and safer than incandescent alternatives. 4.
(3) INSTALLATION 3.1 The cooker hood should be placed at a distance of 65-75cm (26-30inch) from the cooking surface for the best effect. See Pic 1. 3.2 Install the hook in a suitable place once the installation height is fixed, and keep it vertically aligned. The fixed position of the inside chimney bracket determines the location of the chimney. 3.
(4) NOTICE OF INSTALLATION 1. Before installation, please ensure the area is clean, to avoid suction of the remaining bits of broken wood and dust. 2. The canopy hood cannot share the same air ventilation ducting as other appliances, such as gas and electric heaters. 3. The bending of the ventilation ducting should be ≥ 120°, parallel or above the exit vent, and should be connected through the external wall. 4. After installation, make sure that the extractor is level to avoid grease collection at one end.
(6) USE INSTRUCTIONS The re-usable aluminium grease filters supplied with this rangehood should be cleaned every month or so to avoid grease build-up. To remove the grease filter, release the locking mechanism at the front of the filter, and lower the filter slightly to unhook it at the back. Whilst the filter is removed, clean off any residual grease from the housing to avoid fire risk. When replacing the grease filters, ensure that the locking mechanism is facing down.
ORC94XBA The ORC94XBA has a touch control panel. When the power is connected and switched on you will hear a beep and the display screen will be backlit for 30 seconds and the rangehood will go into standby mode. SETTING THE TIME (24 hour time) In standby mode hold down the Timer button (2-3 seconds) until the Hour symbol on the display screen starts to flash. Touch the Add/ON ( ) or Dec/OFF (-) buttons to adjust the hour.
LIGHT The lights work independently of the other functions. Push the light button and the two lighting lamps will come on the display screen will also show a light symbol. Push it again and the lamps will turn off. TIMER The timer can be used to turn off the rangehood automatically after a period of time (5, 15 and 30 minutes). Note: The timer does not affect the lamps.
(7) MAINTENANCE 7.1 Cleaning the grease filter mesh The filter mesh is made of high-density stainless steel. Please do not use corrosive detergent on it. Keeping this filter clean will keep the appliance running correctly. Please strictly follow the guidelines below. Method 1: Place the mesh in 40 - 50℃ clean water, add in a small amount of detergent, and soak for 2 - 3 minutes. Wear gloves, and clean with a soft brush. Do not apply too much pressure, as the mesh is delicate and will damage easily.
(8) TROUBLESHOOTING Fault Cause Solution The fan is blocked Light on, but motor does not work Remove the source of the blockage The capacitor is damaged Contact Omega Service The motor jammed and bearing Contact Omega Service damaged A smell coming from the motor Contact Omega Service Beside the above mentioned, check the following: Light does not work, motor does not work Light damaged/No lights Power cord loose One way valve and the air ventilation entrance are not Oil leakage tightly sealed Leakage
(9) SPECIFICATION Model Rated Input Rated Power Lighting Power Motor Power Air tube diameter Air output Model Rated Input Rated Power Lighting Power Motor Power Air tube diameter Air output ORC93XA 220V-240V, 50Hz 305W 20W X 2 (halogen capsule lamp) 265W 150MM 729m3/h ORC94XBA 220V-240V, 50Hz 305W 20W X 2 (halogen capsule lamp) 265W 150MM 729m3/h ORC94XBA ORC93XA 12
Omega products are distributed in Australia by Shriro Australia Pty Ltd. Locked Bag 5002, Kingsgrove NSW 2208 Phone: 1300 795 572 Fax: (02) 9415 5525 Email: service@shriro.com.au Web: www.omegaappliances.com.
