User manual

INSTALLATION
The adjacent furniture must be able to withstand a minimum temperature rise of 85°C above the
ambient temperature of the room it is located in, during periods of use. The power supply to the
appliance must be cut off before any adjustments or maintenance work is done on it.
PREPARATION FOR INSTALLATION AND USE
Manufactured with best quality parts and materials, this modern, functional and practical oven will meet your
needs in all respects. Make sure to read the manual to obtain successful results so as not to experience any
problems in the future. The information given below contains rules that are necessary for correct positioning
and service operations. They should be read without fail, especially by the technician who will position the
appliance.
CHOOSING A PLACE FOR THE APPLIANCES
There are several points to pay attention to when
choosing a place for your oven. Make sure to take
into account our recommendations below in order
to prevent any problems and dangerous situations,
which might occur later!
When choosing a place for the oven, attention
should be paid that there are no flammable or
combustible materials in the close vicinity, such as
curtains, oil, cloth etc. which quickly catch fire.
Furniture surrounding the oven or cooktop must be
made of materials resistant to temperatures above
85 C°.
Required changes to wall cabinets and exhaust
fans above a built-in cooktop as well as minimum
heights from the oven board are shown in the
diagram. Accordingly, a range hood should be at
a minimum height of 65 cm from the cooktop. If
there is no range hood the height should not be
less than 70 cm. Refer to the range hood instructions for specific details before installation.
INSTALLATION OF BUILT IN OVEN
Insert the oven into cabinet pushing it forward fully. Open the oven door and insert 4 washers & screws (A)
into the holes on insides of the oven frame.
The dimensions and material of the cabinet in which the oven will be installed must be correct and resistant
to increases in temperature. In a correct installation, contact with electrical or insulated parts must be
prevented. Insulating parts need to be fitted in a way to ensure that they cannot be removed by using any
kind of tool. Installing the appliance in the close vicinity of a refrigerator or a deep-freezer is not
recommended as the performance of
the above-mentioned appliances will
be negatively affected due to
emanating heat. After removing your
oven from its packaging, be sure that
the oven is not damaged. If you
suspect any damage to the appliance,
do not use it; immediately contact an
authorised Service Centre.
6