Owner's manual

Figure 2: Closing battery compartment

Note: Be sure to place the rubber protector properly back in its place, to maintain the

MicroLite’s dust and waterproof IP68 compliancy.

As stated previously, replacing the battery will lose the MicroLite’s time/date settings.

These can be restored the next time you Setup the logger using MicroLab Lite.

After replacing the battery, the MicroLite LCD will display PUSH, indicating it is in Push

to Run mode.

Once you connect the logger to the PC’s USB port, you will be able to run the logger

without the need for the magnet.

In addition, you will still be able to download the data previously recorded onto the

MicroLite, before you removed the battery. This data is not lost.

1.6.3. Using the MicroLite Magnet

The MicroLite includes the magnet accessory (stored in the magnet placeholder in the

MicroLite packaging).

This magnet is used to activate the logger when in Push to Run mode. There is a reed

relay on the MicroLite’s circuit board which is closed using the magnet, thereby

activating the logger.

Figure 3: MicroLite magnet holder

To activate the MicroLite when in Push to Run mode, place the magnet inside the small

holder next to the battery compartment for two seconds, and then remove the magnet.

The MicroLite LCD will immediately move to Run mode and live temperature data will be

displayed.

Magnet

holder

Internal

battery

compartment