Owner's manual

Temperature/Pressure Adapter
5
pling be accomplished. Long term monitoring will require less frequent sam-
pling in favor of longer recording times.
The next step is to select how the Service Logger will record the information
from the OM-60-MOD-TP sensor. There are 3 possible ways to record informa-
tion.
Press and hold
RECORD
button until the record display appears. The four re-
cording modes can be scrolled and changed by using
STATUS
or
RECORD
buttons:
1. Record information to memory only. This
option stores information into the Service
Logger’s memory. No printer or computer
connection is required for this function.
2. Record information to a printer. This option
does not store information into memory, but
does print each sample as it is recorded to a
printer. This is referred to as REAL TIME
PRINTING. A printer must be connected for
this function! If no printer is connected, or if
the printer is off-line, or if the printer is out of
paper an error message will be displayed to
alert the user to a problem. Switching to this
option will terminate recording if the Service
Logger was set to record previously.
3. Record information to memory and to a
printer. This is a combination of options 1
and 2. Information is stored in memory and
at the same time each sample is recorded to
a printer. As in option 2., a printer must be
connected and functioning or an error message
will be displayed.
4. If a recording is in progress, this option will
terminate all recording functions. This
option may also be used if the user decides to
cancel a recording session and return to the
operating mode. In order to terminate a record-
ing, press
MENU
ENTER
button again at this time.
Press the
RECORD
button after selecting the
RECORD ON, REAL
TIME PRINT OFF
RECORD OFF, REAL
TIME PRINT ON
RECORD ON, REAL
TIME PRINT ON
RECORD OFF, REAL
TIME PRINT OFF
DAY HOUR MIN
FRI 15 16