User's Manual

11
Operating Instructions
The basic layout of the induction cooktop is shown in the diagram below.
The induction cooktop appliance is operated by touching buttons, with the functions confirmed by LED displays and
acoustic signals.
Turning On and Turning Off the Cooktop Appliance
NOTE: Do not operate the cooktop without first placing a suitably sized cooking vessel containing food on the appropriate
cooking zone. Missing or incorrectly sized cookware will cause the “U” fault to be displayed on the Heat level display
(cooking zone off). Turn off the cooking zone or replace cookware to continue cooking.
If the appliance is in Stand-By-Mode, it is put into Operating-Mode by pressing the On/Off button for at least 1 second. A
beep signal indicates the successful operation acoustically.
On all Heat Level Displays a “0” will appear and all Decimal Points of the Heat Level displays will flash (1 second on, 1
second off).
If there is no operation within 20 seconds, all the Heat Level Displays will automatically turn off. If the displays are turned
off, the hotplates will be re-set into Stand-By-Mode.
If On/Off is pressed for more than 2 seconds (in Operating-Mode), the appliance is switched off and is set into the Stand-
By-Mode again. The appliance can be turned off by pressing On/Off at any time; even if other buttons are pressed
simultaneously.
If there is a residual heat of a hotplate remaining, this will be indicated in the correspondent heat setting Heat Level
Display as a red “H”.
Selecting A Cooking Zone
Select a single cooking zone by pressing the corresponding Heater Selection Button, and the Decimal Point of the
chosen cooking zone turns on. For the selected cooking zone, you can set or adjust the heat level between 1-9 by
touching the Sliding Button at the appropriate point. All of the other cooking zone displays will have a visible “0” or “H” (if
recently used) but they will not have a decimal point.
If left idle for more than 10 seconds, the decimal point on the chosen cooking zone display will turn off (the cooking zone
is no longer selected). Press the Heater Selection Button again to select the cooking zone again. Other cooking zones
can be selected without waiting for the previous one to become inactive.
The Heat Level Display works on a thermostat system. This means that the cooking zone will switch on and off in order to
remain at the chosen Heat Level. NOTE the cooking zone will remain on for longer periods if a higher Heat Level is
chosen, alternatively the cooking zone will be on less regularly on lower Heat Level Settings.
Turning Off Individual Cooking Zones
A particular cooking zone can be turned off in 2 different ways:
A) Selecting the cooking zone & then simultaneously pressing the Sliding Button at either end at the same time, after
which a beep signal sounds and “0” appears in the Heat Level Display.
B) Reduction of the heat setting to “0” by operating the Sliding Button to the left. When this happens, the associated
Decimal Point of the cooking zone will also be turned off. If there is residual heat from this hotplate remaining, a red “H”
will be shown in the Heat Level Display area.