Owner's manual

32
4.3.5.2 Configuration - Recording Active
Once the Clock Time has reached or exceeded the Start Time, click on the “Read
Settings” button, followed by the “Update” button, to refresh the Configuration page, see
Figure 4.14.
Section D will have a new message Flash Recording On, and Section J will still show
the current Recording Settings.
Stop Recording Button: Click on this button to stop an ongoing recording.
Figure 4.14 Configuration (Recording Active)
http://192.168.1.50
CONFIGURATION
Terminal Server
Alarm Setup
2-MegaBytes Flash Card 0 Kbytes Used Space
Flash Recording On. AC Power On. Check Battery
Input Contact Closure
Remote Access (Tunneling)
Update
Stop Recording
Read Settings Hard Reset
Remote IP Address:
Remote Port:
Remote Access:
TCP/UDP: Server Type: Forward CR
Number of Connections 5 Port:
2000
Command
TCP
2000
Disable
0.0.0.0
Main Menu
Disable
Normally Open Normally Close Active High
Contact 1: Contact 2: Active Contact Output:
Output Type:
Time Stamp:
High/Low
Unlatch
High/Low
Unlatch
032.5
082.5
nnn.n
nnn.n
025.5
065.5
nnn.n
nnn.n
Address
J
K
I
Flash Recording Settings
Type:
Full Flash
Interval:
10_sec
Start Date:
06/09/2009
End Date:
mm/dd/yyyy
mm/dd/yyyy
09/12/2009
Time:
12:00:00
Time:
hh:mm:ss
Clock Date:
06/09/2009
mm/dd/yyyy Time:
12:00:25
hh:mm:ss
hh:mm:ss
15:15:13
Input 1 Alarm:
Input 1 Status:
Input 2 Alarm:
Input 2 Status:
SP1_L:
SP1_H:
SP2_L:
SP2_H: