Owner's manual

30
4.3.5 Configuration (continued)
Figure 4.12 Configuration - Flash Recording Settings
Type: The selections are: “No Recording”, “Limited”, and “Full Flash”.
No Recording: Not used.
Limited: You must define the Start Date and Time, and End Date and Time in which
you need the recording to be done.
Full Flash: You only need to define the Start Date and Time.
The iSE will record data until the Flash is full, then the iSE will stop recording.
The End Date and Time will be automatically updated, it is calculated
according to the recording interval and Flash Card size.
Interval: The recording interval at which the temperature values are being stored into
the Flash Card. The selections are “10 seconds“ and “1 minute“.
To avoid any miscommunications when downloading the stored data using
the iFlash program or from the “Chart” page, it is strongly recommended to
let the recording run for a minimum of 3 minutes if the time interval is 10
seconds (from the “Configuration” page), and 15 minutes if the time interval
is 1 minute.
Clock Date and Time: Real Time Clock, carried over from Configuration Page, you
may update it here as needed.
Start Date, Time: Starting date and time for recording. Entry is required for Limited and
Full Flash types of Recording.
End Date, Time: Ending date and time for recording. Entry is required for Limited
type of Recording only.
The Date and Time formats are mm/dd/yyyy and hh:mm:ss. Time is military
time / 24 hour based. The exact formats are required otherwise an Entries
Error message will appear in Section D (Figure 4.13).
Flash Recording Settings
OK
Read Settings Hard Reset
WARNING! New Recording Will Erase Existing Data. Download Data or Replace Flash.
To Continue, Complete Recording Settings and Click OK. To Cancel, Click Update.
Main Menu
Type:
Full Flash
Interval:
10_sec
Start Date:
06/09/2009
End Date:
mm/dd/yyyy
mm/dd/yyyy
09/12/2009
Time:
12:00:00
Time:
hh:mm:ss
Clock Date:
06/09/2009
mm/dd/yyyy Time:
11:54:20
hh:mm:ss
hh:mm:ss
15:15:13
K
J
I
Update