Owner's manual
24
4.3.4 Access Control
This section describes the "Access Control" page of the iSE’s Web interface. This page
allows the users to set up the network and security parameters of the iSE.
At the initial entrance to the “Access Control” page you will be prompted for the LOGIN
Password (see Figure 4.6) prior to an ADMINISTRATOR Password.
Figure 4.10 Access Control
Login Password: This allows users to access and modify all of the iSE Home Page menu
items, except “Access Control”, which requires an Administrator password. The default
Login password is 12345678. This password can be up to 16 alpha-numeric case-sensitive
characters. If there is no Login Password assigned (blank box) the iSE will not require a
password to access and modify iSE Home page menu items.
Admin (administrator) Password: This allows users to access and modify the "Access
Control" page. The default password is 00000000. This password can be up to 16 alpha-
numeric case-sensitive characters. If there is no Administrator Password assigned (blank
box) the iSE will not require password to access and modify "Access Control" page.
Secured Reading & Chart: If checked, the LOGIN password is required to open “Read
Sensor” and “Chart” Java applets.
Host Name: Refer to Section 3.4, DNS.
MAC Address: This is also called Hardware address or Ethernet address, which is
assigned to the iSE at production. The MAC (Media Access Control) address is the iSE’s
unique hardware number and is not changeable.
IP Address: The IP (Internet Protocol) address is a 32-bit number that identifies each sender
or receiver of information that is sent in packets across the Ethernet or the Internet. The iSE’s
default IP address is 192.168.1.200. The iSE’s IP address should be changed to fit user’s
networking environment. Consult with your IT department for obtaining an IP address.
ACCESS CONTROL
ACCESS CONTROL
http://192.168.1.200
Address
Main Menu
Login Password: 12345678
Admin Password:
00000000
Secure Reading & Chart:
Disable
IP Address: 192.168.1.200
Camera IP: 0.0.0.0
Gateway Address:
0.0.0.0
Camera Label:
Camera Location
Subnet Mask:
255.255.255.0
MAC Address: 00:03:03:00:21:D9
Host Name: eis21d9
Save
The DHCP can be
enabled by setting the
dip switch number 3
to ON position.
Changes made in the
iSE’s Access Control
page can be saved
permanently by
pressing the Save
button.
If you change a field and
press Save, this message
will appear
Power is Recycling. Reconnect to the iServer.