Owner's manual

6
2.2 DIP Switches
The iSE is shipped with all DIP switches in "OFF" position.
Figure 2.3 DIP Switch Location
To set the iSE to factory default settings, slide DIP switch #2 to ON position.
Power the iSE on and wait about 10 seconds until the iSE fully boots up.
Set the DIP switch #2 back to OFF position (it does not matter if the iSE is powered ON
or OFF, just make sure that the DIP switch is set to OFF, otherwise, every time the unit
is power-cycled the factory settings will take over.
DIP Switch Usage
1) N/C - not used
2) To change to default factory settings
3) To enable/disable DHCP
4) N/C - not used