Owner's manual

4.3.4 Sensor Parameter
In the first column of Configuration’s page, click on 1
to view and modify Sensor
Parameters. See Figure 4.9.
Figure 4.10 Sensor Parameters
Below are some definitions of terms used in the Sensor Parameter page.
Sensor Name
: shows on the “Configuration” and “Read Sensor” page, this is a text field
and can take up to 16 alphanumeric characters.
Reading Command
: Can be set as the following:
SRTC Read the temperature in °C.
SRTF Read the temperature in °F.
SRHb Read the pressure in kPa.
SRH# Read the pressure in PSI
SRHK Read the pressure in kg/cm
2
.
You may type any ASCII characters in the first two boxes, but you must delete
the leading spaces.
Display Units: unit of temperature (°F or °C) or unit of pressure (kPa, PSI, kg/cm
2
) shown on
the
“Read Sensor” page .
SENSOR PARAMETERS
Sensor No. 1
Sensor Name:
Main Menu
http://192.168.1.200
Sensor Parameters
Update Reset
Temperature
Reading Command:
SRTC
Display Units:
C
Remote Display Format:
Remote End Char (Hex)0x:
T0000.0C
0D
Offset:
( C or kPa)
0000.0
Cancel
21