Owner's manual

ManualsBrandsOmega ManualsDomestic AppliancesHH91 and HH92

15. Relative time clock readout

16. min:sec. Relative time units

17. CAL. Flashes during calibration

18. INTERVAL. Not used on HH91 and HH92

19. hour:min. Relative time units

20. Type KJTERSN. Indicates selected thermocouple

type

SETUP INSTRUCTIONS

INSTALL BATTERY

To open the battery compartment, turn the

thermometer over and lift the flip-up stand (Fig. 1,

Callout 6) to gain access to the battery compartment

(Callout 7). Remove the single Philips-head screw

securing the battery compartment cover. Set the

cover and screw aside. Obtain a “9V” battery and

install it in the compartment observing the polarity

markings inside. Close the battery compartment by

replacing its cover and securing it with

the screw.

PERFORM SETUP PROCEDURE

The setup procedures for the HH91 AND HH92 are

identical, with one exception: Step 2—adjusting the

temperature compensation (offset) value—must be

performed twice, for the thermocouples of both

channels.

1. Set TC type

2. Set TC

offset

5. Set power

line

frequency

4. Set relative

time clock

6. Enable/

disable

ambient

temperature

compensation

3. Set APO

trigger

7. Enter

Calibration

mode