Owner's manual

METER BUTTONS
T-RST button - Clears the tare value.
£/MAX button - In the run mode, press the £/MAX button to show the
maximum value if jumper S3 is installed: the meter momentarily shows
“####”, then flashes the maximum value encountered since the last peak
reset. Press the £/MAX button to show the VALLEY value if jumper S3 is
removed: the meter momentarily shows “™™™™”, then flashes the minimum
value encountered since the last valley reset. In the configuration mode, press
the £/MAX button to change the flashing digit’s value (increments by one).
£/TARE button - In the run mode, press the £/TARE button to tare the
display value to zero. In the configuration mode, press the £/TARE button to
scroll through available choices, or to move one digit to the right.
MENU button - In the run mode, press the MENU button to enable meter
configuration changes. Refer to specific procedure for more details.
RESET button - In the run mode, press the RESET button to reset the Peak
and Valley registers: the meter momentarily shows “PrSt” or “VrSt” , then
resets both values. In the configuration mode, press the RESET button twice
quickly to escape from the configuration mode.
4