Operation Manual
CLEANING OPERATION
Omega blender container parts are corrosion resistant, sanitary and easily cleaned.
Do not put the container assembly & blender base assembly in the dishwasher.
1. Before rst use and after every use, separate container parts from the base
2. Add cleaning solution to the container. Use washing solution of tepid water
(less than 115°F/46°C) and a non-sudsing detergent. Use the recommended
amount of detergent.
3. Scrub and ush out the container interior lid and feeder cap to remove food residue.
Empty container.
4. Fill container 1 /4 full with fresh washing solution and place it on the base.
5. Replace the lid on the container and run the blender on high speed for 2 minutes.
6. Repeat step 4 using clean rinse water (95°F/35°C).
7. Wipe down the container, feeder cap, and lid with a soft cloth or sponge,
dampened with fresh washing solution.
8. Wipe the exterior of the base with a damp cloth or sponge. The base contains
electrical components: do not immerse, use a high-pressure washer, or use a
dishwasher to clean the base.
CARING TIPS
To care for your blender, please read the tips as follows:
1. Periodically check all parts before reassembly, as use of damaged or
non-recommended parts could result in a severe personal injury and/or damage
to the blender.
2. Blades:
If the processing blades are stuck or difcult to turn, DO NOT USE BLENDER
(Check by carefully turning the blades in a counterclockwise direction,
where the opposite edges are sharp. Blades should turn freely.)
3. Container:
If the EASTMAN TRITAN container is cracked, DO NOT USE BLENDER, further use
could result in the container breakage during use.
4. Blender Base:
Never immerse the blender base in water. Unplug unit. The housing can be cleaned
with a damp cloth.
5. Motor:
The motor is permanently lubricated and does not require any additional lubrication.
7