Product Manual
OPERATION
NOTE: For bestresult, use an approved tire bead
lubricant before removing or installing tire on rim.
1. Remove the wheel from the vehicle and secure on a
suitable work surface. Fully deate the tire,remove
valvecore,andallbalanceweights.
2. Hold and position the bead breaker under the rim
ange.Positiontheclawontheinnerpartoftherim,
with the bead breaker feet against the outer part of
therim(RefertoFigure3).
3. Operate the pump to close the claw portion and
simultaneously press against the bead surface. To
stoporhold,simplyceasepumpoperation.
4.Withtheclawpushingagainsttheinnerpartofthe
rim,theshovelandfeetpushagainstthelateralring
and the bead of the tire.
5. Continue operating the pump until the bead separates
from the tire rim surface.
6.Torelease,simplyreleasethehydraulicpressureof
pump by opening the release valve on the pump or
ifatreadlepump,actuatethereleasepedal.
7. Continue this operation around both outboard and
inboard sides of the rim until the bead is free.
4
Figure 3 - Operating Illustration
! WARNING
• Study, understand, and follow all instructions
provided with/on this product before use.
•
Do not exceed rated capacity or rated pressure.
•
Properly secure and support vehicle before
removing the tires.
•
Always wear protective gear and clothing.
•
Ensurethatthewheelandtirearesecurely
supported and positioned before breaking the
bead.
•
Never attempt to install or mount any tire and rim
that are mismatched.
• Keep hands away from
pinch and crush points
that can be created during operation.
•
Keephydraulicequipmentawayfromamesand
heat.
•
Use only manufacturer recommended hydraulic oil.
•
Do not alter or modify this product.
•
Failure to heed these markings may result in
personal injury and/or property damage.
! DANGER
To avoid serious injury or death:
• NEVER use this device on split rims / multi-piece
rims!
• REMOVE tire from vehicle and deate completely
before attaching bead breaker to tire / wheel!