Product Manual

SET UP
(RefertoFigure1&2)
1.Remove the plugonoil port, connect 3/8" NPTF
hydraulicconnectiontooilport,i.e.coupler,hydraulic
hose,tting etc. Ensurethe oil ports and thread
connections are clean before connecting to the
hydraulic system.
NOTE: Alwayssecurethreadedconnectionswithnon-
hardening pipe thread compound. Take care not to
introducecompoundintoportorices.Tightensecurely
to prevent accidental removal of components while in
use.
2. Connect the hydraulic connection to hydraulic pump.
3. Install a pressure gauge to monitor the system
pressure.
WARNING: DO NOT exceed rated pressure of
10,000 psi.
3
Figure 2 - Typical Installation Illustration
Bead Breaker
*Hydraulic Connections
i.e.Couplersandtting
(3/8"-18NPTF)
*AirActuated
Hydraulic Pump
*Hydraulic Hose
AirSupplyInlet
(*)Itemsnotincludedwithunit
BEFORE USE
1. Verify that the product and the application are
compatible,ifindoubtcallOmegaTechnicalService
(888)332-6419.
2.Beforeusingthisproduct,readtheoperator'smanual
completely and familiarize yourself thoroughly with
the product, its components and recognize the
potential hazards associated with its use.
3. Replace worn or damaged parts and assemblies with
factory authorized replacement parts only.Lubricate
asinstructedinMaintenanceSection.
4. Use adequate eye protection when operating or near
this equipment.
!