Product Manual

3
BEFORE USE
1. Verify that the product and the application are
compatible, if in doubt call Omega Technical
Service [phone].
2. Before using this product, read the operator's
manual completely and familiarize yourself
thoroughly with the product, its components and
recognize the hazards associated with its improper
use.
3. Locate and open the release valve
(counterclockwise no more than 2 full turns).
4. With saddle fully lowered, locate and remove the oil
filler plug. This will help release any pressurized air
which may be trapped within the reservoir. Ensure
the oil level is just below the oil filler plug hole.
Reinstall the oil filler plug.
5. Check to ensure that jack rolls freely and that the
pump operates smoothly before putting into service.
6. Air actuated product is fitted to accept the popular
1/4" PT air nipple. When installing 1/4" PT nipple of
your choice, ensure that thread tape or compound
is used when servicing connections. To help ensure
trouble free operation, an inline air dryer and oiler is
recommended.
Important: Do not wire, clamp or otherwise disable
the lift control valve to work by any means other than
by using the operators hand. Always lift only on areas
of the vehicle as specified by the vehicle manufacturer.
Do not use adapters or accessories that are not
provided initially.
OIPM#22040-SJ2
Figure 1 - Model 22040, 22050, & 22100 Nomenclature
handle position lock
release valve
(handle knob)
saddle
foot pedal
oil filler plug
(on reservoir)
handle
Study, understand, and follow all instructions
provided with and on this device. Do not exceed
rated capacity. This is a lifting device only. After
lifting, immediately transfer the load to
appropriately rated vehicle stands. Never work on,
under, or around a load supported by this device.
Use only on hard, level surfaces capable of
sustaining rated capacity loads. Do not move or
dolly loads with this device. Do not modify this
device. Failure to heed these markings may result
in personal injury and/or property damage.
!
WARNING
ASSEMBLY
Little, if any, assembly is required of these jacks.
Always secure the handle into the handle fork by
means of the bolt and lock washer provided. Tighten
securely to prevent accidental removal of handle while
in use. Familiarize yourself with the illustrations in the
operator's manual. Know your jack and how it operates
before attempting to use.
Figure 2 - Model 22041, 22051, & 22101 Nomenclature
saddle
lift control
valve
handle
sleeve
oil filler plug
(on reservoir)
release valve
(handle knob)
handle
handle position lock