Product Manual

2
OIPM#22040-SJ2
Save these instructions. For your safety, read, understand, and follow the information provided with and on this
jack. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product may
require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's native
language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack, remove
from service immediately. Inspect before each use. Do not use if broken, bent, cracked, or damaged parts
(including labels) are noted. Any jack that appears damaged in any way, operates abnormally or is missing parts,
shall be removed from service immediately. If the jack has been or suspected to have been subjected to a shock
load (a load dropped suddenly, unexpectedly upon it), immediately discontinue use until jack has been checked by a
Omega authorized service center. It is recommended that an annual inspection be done by qualified personnel.
Replace worn or damaged parts and assemblies with Omega Authorized Replacement Parts only. Labels and
Operator's Manuals are available from manufacturer (see Replacement Parts, pages 6 thru 8).
PRODUCT DESCRIPTION
Omega Long Chassis Hydraulic Service Jacks are designed to lift, but not sustain, rated capacity loads. Always
reference the Product Label and Operator's Manual to establish rated capacity. There are 6 different styles in this
category ranging from 4 thru 10 tons in capacity. Various styles include the Service Jack with Foot Pedal (22050),
the Air/Lever Actuated Service Jack (22051). Each is designed to be used in conjunction with jack stands. Intended
use: To lift one axle of a vehicle for the purpose of service and/or repair of vehicle components. After lifting, loads
must be immediately supported by appropriately rated jack stands. Check with vehicle owner's manual for proper lift
points. Those air actuated units require at least 7.8 CFM @ 90 - 175 PSI.
DO NOT USE AS A WHEEL DOLLY. DO NOT USE FOR ANY PURPOSE OTHER THAN THAT LISTED ABOVE.
SPECIFICATIONS
Min. Height
57 3/4" x 16 7/8" x 7 5/8"
53 1/8" x 14 3/4" x 7 1/2"
Max. Height
22050
22051
22100
22040
4 Ton
5" 24"
22041
4 Ton
5"
24"
5 Ton
57 3/4" x 16 7/8" x 7 5/8"
7"
27"
5 Ton
7" 27"
10 Ton
7"
27"
Jack Size ( L X W X H )CapacityModel
22101
10 Ton
54 3/4" x 20" x 12 3/4" 7"
27"
54 3/4" x 20" x 12 3/4"
53 1/8" x 14 3/4" x 7 1/2"