Product Manual

ManualsBrandsOmega ManualsAutomotive5-Ton Hydraulic Long Chassis Service Jack

Model Number

22040

22041

22050

22051

22100

22101

Capacity

4 Ton

5 Ton

10 Ton

(Air/Lever Actuated Model)

Model 22040, 22050, 22100

Model 22041, 22051 & 22101

Long Chassis

Hydraulic Service Jacks

Operating Instructions

& Parts Manual

OIPM 22040-SJ2

Printed in Taiwan

10939 N. Pomona Avenue

Kansas City, MO 64153

Summary of content (8 pages)

PAGE 1
Operating Instructions & Parts Manual Long Chassis Hydraulic Service Jacks Model Number 22040 22041 (Air/Lever 22050 22051 (Air/Lever 22100 22101 (Air/Lever Actuated Model) Actuated Model) Actuated Model) Capacity 4 Ton 4 Ton 5 Ton 5 Ton 10 Ton 10 Ton Model 22040, 22050, 22100 Model 22041, 22051 & 22101 Shinn Fu Co. of America, Inc. ©2002 10939 N.
PAGE 2
Save these instructions. For your safety, read, understand, and follow the information provided with and on this jack. The owner and operator of this equipment shall have an understanding of this jack and safe operating procedures before attempting to use. The owner and operator shall be aware that use and repair of this product may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's native language before use of this jack is authorized.
PAGE 3
handle position lock handle position lock release valve (handle knob) handle release valve (handle knob) saddle saddle handle lift control valve foot pedal oil filler plug (on reservoir) oil filler plug (on reservoir) handle sleeve Figure 1 - Model 22040, 22050, & 22100 Nomenclature Figure 2 - Model 22041, 22051, & 22101 Nomenclature BEFORE USE ASSEMBLY 1. Verify that the product and the application are compatible, if in doubt call Omega Technical Service (888)332-6419. 2.
PAGE 4
OPERATION MAINTENANCE Lifting 1. Place vehicle in park, with emergency brake on and wheels securely chocked to prevent inadvertent vehicle movement. 2. Locate and close release valve by turning handle or handle knob clockwise, (depending on model) firmly. Center jack saddle under lift point. 3. Verify lift point, then use handle pump or foot pedal to contact lift point. To lift, pump handle or squeeze lift control valve until load reaches desired height. Never use foot pedal to raise load. 4.
PAGE 5
TROUBLESHOOTING Symptom Possible Causes Corrective Action Jack will not lift load • Release valve not tightly closed • Ensure release valve tightly closed • Overload condition • Remedy overload condition • Air supply inadequate • Ensure adequate air supply Jack will lift, but not maintain pressure • Release valve not tightly closed • Ensure release valve tightly closed • Overload condition • Remedy overload condition • Hydraulic unit malfunction • Contact Omega Tech.
PAGE 6
Models 22040 and 22041 Parts No.
PAGE 7
Models 22050 and 22051 Parts No.
PAGE 8
Models 22100 and 22101 Parts No.