User manual

DaqBoard/2000 Series Board Connection
Use a 37 pin accessory cable to connect the P2 digital I/O port of the DaqBoard/2000 Series P4 adapter to
the P2 connector of the DBK24 using an accessory cable (with -x indicating the number of expansion units
to be connected). Select up to 8 positions for a total of 192 programmable isolated inputs.
P4 adapters are discussed in the DBK200 document modules.
P2 expansion cables must be kept short for proper operation.
Do not exceed 14” per attached DBK card.
DaqBook and DaqBoard Configuration
The DBK24 requires no hardware configuration setups internal to the DaqBook or DaqBoard.
LogBook Connection
Connect the P2 digital I/O port of
the LogBook to the P2 connector
of the DBK24 using an accessory
cable (with -x indicating the
number of expansion units to be
connected). Select up to 8
positions for a total of 192
programmable isolated inputs.
Software Setup
Reference Notes:
o DaqView users - Refer to chapter 3, DBK Setup in DaqView.
o LogView users - Refer to chapter 4, DBK Setup in LogView.
Note: Refer to the full-page table on the next page for valid hex codes.
DBK Option Cards and Modules 879795 DBK24, pg. 5