User manual

DaqBook/100 Series & /200 Series and DaqBoard [ISA type] Configuration
Use of the DBK17 requires setting jumpers in DaqBook/100 Series & /200 Series devices and
ISA-Type DaqBoards.
1. If not using auxiliary power, ensure that the JP1 jumper is in the expanded analog mode (see figure).
Jumpers on DaqBook/100 Series, /200 Series, & ISA-Type DaqBoards
Note:
These jumpers do not
apply to /2000 Series
devices.
Note: The JP1 default position (above figure) is necessary to power the interface circuitry of the DBK17
via the internal +15 VDC power supply. See the following CAUTION regarding JP1.
CAUTION
If using auxiliary power, for example a DBK32A or a DBK33, you must remove
both JP1 jumpers. Refer to Power Requirements in the DBK Basics section and to
the DBK32A and DBK33 sections as applicable.
2. Place the DaqBook/100 Series or DaqBook/200 Series device’s JP2 jumper in the SSH position.
CAUTION
Do not use an external voltage reference for DAC1. Applying an external voltage
reference for DAC1 when using SSH output will result in equipment damage due to
a conflict on P1, pin #26.
3. For DaqBook/100, /112 and /120 only, ensure that the JP4 jumper is in single-ended mode.
DaqBook/2000 Series and DaqBoard/2000 Series Configuration
No hardware configurations are required for the DaqBook/2000 Series or DaqBoard/2000 Series devices.
Software Setup
Reference Notes:
o DaqView users - Refer to chapter 3, DBK Setup in DaqView.
o LogView users - Refer to chapter 4, DBK Setup in LogView.
DBK17, pg. 4 879895 DBK Option Cards and Modules