User's Manual

DisplayHi: Defines the high scale for a pen on the display.

StatusBar: For users convenience when viewing the status of Totalizer, Counter, DI or DO.,

the user may enable these items in the StatusBar. For example, after enable Totalizer 1∼3, an

extra bar of Totalizer 1, 2 & 3 will appear at the lower part of display.

Figure 4 – 4

Note:

◆ To illustrate the difference between DisplayHi, DisplayLo and Scale Hi, Scale Low. Here

is a typical example, with input 0-10V, Scale Low=0.00, Scale Hi=100.00, to have better

resolution and vision on Bar, set DisplayLo=0.00, DisplayHi=50.00 so that the Bar

displays from value 0.00 to 50.00.

◆ The decimal point is defined by Scale Hi and Scale Low, and not by DisplayHi, or

DisplayLo.