Instruction Manual
8
START UP AND STOP
CHECKING THE CORRECT ELECTRICAL CONNECTION
ATTENTION!
Check that the feeding line corresponds to the value reported on the identication plate of the machine and
that it is outtted with an efcient oor plug.
1. Put the plug into the electrical outlet.
2. Set the differential switch in position “I”. The lit indicator, indicating that the machine is powered, must be
illuminated.
3. Press the pushbutton to start and immediately afterwards press the stop one, checking the rotation
direction of the roller.
NOTE
The presser must be in a low position.
The roller rotation direction must be the same as the one indicated by the arrow.
CHECKING THE PRESENCE AND EFFICIENCY OF PROTECTIONS AND SAFETIES
1. Microswitch on the lever.
While the machine is running lift the presser until the microswitch intervenes and stops the machine.
Keep the presser still in the point in which the microswitch intervenes and check that the space between
the loading inlet and the presser is such to block ngers from entering. If this is not the case contact an
authorized reseller or the manufacturer.
2. Microswitch on the lever.
While the machine is running extract the plexiglass container and make sure that the machine stops.
Operation