User's Manual

Getting Started
1. Please charge Omago Intelligent Diaper sensor battery fully before starting to use.
2. Download “Omago” APP from iOS App Store or Google Play and install.
3. Open “Oamgo” APP and register user detail.
Installation
1. Press “+” on Device list
2. Select “Gateway” and scan the bar code on the bottom of Gateway.
3. Select “Diaper Sensor” and scan the bar code on Intelligent Diaper Sensor. You can
find both Gateway and Intelligent Diaper Sensor on the device list.
4. Plug power cord into Gateway to power on, the Gateway led blinks red.
5. Press “Gateway” on device list for connecting to WiFi.
i) Select SSID from smartphone “Setup” WiFi connection.
ii) The SSID is “GatewayWifiConfig”.
iii) If SSID connecting successfully, it will pop-up WiFi list and then choose the
network name used at Home and key-in the password at this page。
iv) If WiFi connecting successfully, the page will be closed automatically and the
Gateway LED will blink blue. If not, please repeat above process.
6. Put “Intelligent Diaper Sensor” on flat surface for sleep posture calibration and press
sensor button for 3~5 seconds for connection to Gateway. If connection successfully,
the Gateway led will become breathing green light. If not, please repeat above
process. Please be noted, must put the sensor on a flat surface for calibration
accuracy. If not calibrating accurately, it may affect sleep posture accuracy. The
sleep posture detection function is for assisting to parents and for information only.
Parents still has to look after the baby all the time.
Starting to use
1. After installation, please go back to APP and press “Cloud” button on Sensor device
list for indoor use. The Gateway led will become breathing green light
2. The APP will enter main page. Put Intelligent Diaper Sensor into strap and stick to
the position of the diaper corresponding to the human excretory hole to get the best
effect. You can start to experience the convenience of “Omago IntelligentDiaper
Sensor”.
3. If the sensor is out of Gateway connection range, the sensor led will blink red and
APP pop out warning message. Press “BLE” button on Intelligent Diaper Sensor on
device list for outdoor use. The Intelligent Diaper Sensor will connect to your
smartphone for continue service. The Gateway led will blink blue.
When the Intelligent Diaper Sensor coming back to Gateway connection range, it will
connect to Gateway automatically.
4. The Gateway will detect crying and pop-out dialog on smartphone. Please keep the