Safety Instructions

46
Press the SEND TO LINE button.
Press LOAD on the OM4001A to start
loading.
You can see the loading progress on the bar
graph
You will see this screen after the firmware
was successfully loaded
Usually, it takes about 30 seconds but
sometimes it might take a little bit longer.
NOTE: Do not take any action until this screen disappears!
At the end you will return to the main screen of OM4001A. Switch PA OFF, disconnect the TCVR serial
cable and you are ready to use the OM4001A with the new firmware.
Type of supported TCVR and
working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the display.
AUTO LED is ON.