Safety Instructions

7.3. OM4001A Remote Control

The OM Power team has developed special software which allows controlling the PA OM4001A remotely.

Download it from the official OM Power website http://www.om-power.com/downloads. The software

allows the following controls:

• Switch the PA ON and OFF

• Switch between STBY and OPERATE

• Switch between preprogrammed antennas

• Read and reset the last 20 warnings and fault messages

• Manual fine tuning of the PA Tune and Load

• To check most operating parameters of the PA

• Selection of different screens for the PC display

• Antenna retuning if parameters changed

Have a look on the next pictures and follow instructions to setup remote control properly.

Connection setting:

Set up TCP/IP address and port: