Safety Instructions

28
Press SAVE for writing values to the
memory and press EXIT.
NOTE: Repeat M-TUNE adjustment
process for other segments / bands as
required.
Below is an example of an M-TUNE situation. First we will check driving power from the transceiver. Stay
in STBY mode, press PTT and apply RF power.
Measured driving power is 30 Watts.
Now switch to OPER, press PTT and
apply RF from TCVR. See the following
picture.
Output power is 4113W, reflected
power about 1W and screen current is
about +50 mA.
NOTE: If your antenna impedance is
different than real 50 Ohms then can
be necessary to start the M-TUNE
procedure to optimize the PA tuning.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.