Safety Instructions

26
Similar ways EBS2 can be preprogrammed (300mA by AUTO set).
Or another value of EBS2 by MANUAL setting. Do not forget to adjust the same values for both tubes.
Scroll to CALIBRATION Ip, Is and press
SET. Calibration will be done
automatically.
Scroll to SWR PROTECT and press SET.
This feature allows user to switch OFF the
SWR This feature allows the user to
switch OFF the SWR protection.
We recommend to set it ON (SWR
protection circuit will stay active, max.
allowed SWR is 3:1). If OFF is selected,
higher SWR is allowed, but reflected power is measured. If it exceeds 350W, transmit will be blocked.
5.4. Operation mode
Before switching to operation mode, check all connections between PA and TCVR.
We are now back in the Main display, bar
graphs defined, antennas
preprogrammed, CAT was set. We are
ready to go to the operation mode.
Press the black STBY/OPER button on the
front panel.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.
Type of supported TCVR and working
frequency are visible on the display.
AUTO LED is ON.