Safety Instructions

20
The INFO settings allows viewing
all of the previous PA
INFORMATION screen plus the
addition of one more touch key to
enter the UPGRADE mode.
UPGRADE touch button should
ONLY be used if the EEPROM or
firmware files (or both) will be
upgraded. In such a case see page
45.
5.3. Preparing for operation
In STBY the amplifier is in bypass-mode and your transceiver is directly connected to the
antenna. Maximum allowed power in bypass mode is 200 Watts! The bypass RF power is
displayed if PA is in standby mode.
To turn PA ON press ON/OFF button on the front panel (black one) and hold it abt. 1 second. PA will start
tube heating. It will take 180 seconds. Turning PA ON is possible ONLY from the home screen! If you have
other display active, press EXIT more times to go back to the home screen. (These same functions are
also available on the OM Power Remote Control PC Application)
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.
Type of supported TCVR and
working
frequency are visible on the
display.
AUTO LED is ON.