User manual

299 EN
Information
10
4
Adjust ash settings.
• Highlight items using the FGHI buttons and rotate the front dial to choose
settings.
Group, ash control mode
Flash compensation
±
0.0
±
0.0
A Mode
RCRC
0.0
5.6250P
Ch1Low
TTL
Off
Off
A
Small
1/ Auto
ISO
#
#
x
G
3
0
+
-
C
B
[
1:02:03
]
1023
r
±
F
200
WB Auto
Channel
Optical signal strength
Flash mode
Group
Choose a group. Changes to settings apply to all units in the
selected group. The unit mounted on the camera works as a
member of Group A.
Flash control mode Choose a ash mode.
Flash compensation
Adjust ash output. When [Manual] is selected for ash mode,
you can a value for manual ash output.
Optical signal
strength
Choose the brightness of the optical control signals emitted by
the ash units. Choose [High] if you have placed ash units at
close to the maximum distance from the camera. This setting
applies to all groups.
Flash mode
Choose # (standard) or FP (super FP). Choose super FP for
shutter speeds faster than the ash sync speed. This setting
applies to all groups.
Channel
Choose the channel used for ash control. Change the
channel if you nd that other light sources in the area are
interfering with remote ash control.
5
Set the unit mounted on the camera to [TTL AUTO].
• Flash control settings for the FL-LM3 can only be adjusted using the camera.
# Position the wireless units with the remote sensors facing the camera.
# Take pictures after conrming that the ash units are charged.