Use Instructions
Table Of Contents
- 1 About this manual
- 2 Safety
- 3 Hinweise zum Aufstellen
- 4 Tools and accessories
- 5 Scope of supply
- 6 System diagram
- 7 Trays
- 8 Specifications
- 9 Unboxing
- 10 Mounting of components
- 11 Mounting fluorescence components
- 12 Assembly of the housing for scanner
9 Unboxing
Transportation lock (2) and (3)
ATTENTION
The transportation locks must be remounted each time before the unit is trans-
ported. Make absolutely sure not to lose the transportation locks and the
mounting material.
Hex screwdriver (size 3mm)
1. Remove the red two-part transportation locks from the SCARA robot arm.
To do so, loosen the 8 hex screws (size 3 mm) indicated in the figure.
9.4.3 Removing transportation lock from SCARA robot arm’s coun-
terweight
The units described below must be assembled and adjusted by Olympus. If these units are
assembled or adjusted by the customer, the operations are not ensured.
- 35 -
Instructions for useOLYMPUS VS200 System